Goodman 1.5 Ton 14 SEER2 AC & Gas Furnace System – Multi-Speed, 60000 BTU Gas Furnace, 92% AFUE, Upflow, R32
Check current price on AC Direct →
Key features
- 1.5-ton capacity suited to smaller spaces, roughly 500 to 800 sq ft depending on load
- 14 SEER2 efficiency meets current federal minimums without premium-tier pricing
- 92% AFUE upflow gas furnace delivers efficient heating in a basement or closet install
- Multi-speed blower motor for improved airflow control versus single-speed units
- R-32 refrigerant with a lower global-warming potential than legacy R-410A
- Goodman 10-year parts warranty when registered within 60 days of installation
About this system
The Goodman GLXS3BN1810D pairs a 1.5-ton, 14 SEER2 single-stage air conditioner with a 60,000 BTU, 92% AFUE upflow gas furnace and uses R-32 refrigerant. At 1.5 tons, this system is sized for smaller homes, condos, or individual zones in the 500 to 800 square foot range, depending on local climate and insulation levels. The 14 SEER2 rating clears the federal minimum for most U.S. regions without reaching into premium-efficiency territory, which keeps the purchase price down at the cost of slightly higher long-term energy bills compared to 16 SEER2 or higher equipment.
The 92% AFUE furnace means roughly 92 cents of every dollar spent on gas becomes usable heat, a meaningful step above the 80% AFUE entry tier but short of the 95 to 98% condensing furnaces at the top of the market. The upflow configuration suits a basement or closet installation where air exits the top of the furnace into ductwork above. R-32 is a lower global-warming-potential refrigerant that is becoming standard in residential equipment, though it does require technicians who are specifically certified to handle it. The multi-speed blower motor gives this system some flexibility in airflow delivery, which can improve comfort and humidity control compared to a fixed-speed unit.
The Goodman GLXS3BN1810D is a straightforward, budget-accessible system that gets the job done for smaller homes without overspending on efficiency or features you may not need. Its long-term performance depends more on installation quality and maintenance discipline than on the equipment itself, which is consistent with how Goodman positions across its entire lineup. Buyers who need a reliable workhorse at a lower upfront cost will find it reasonable; those who want premium longevity or worry-free ownership should budget up.
Overall score is the average of the five ratings above.
What we like
- Purchase price runs 15 to 25 percent below comparable Carrier, Trane, and Lennox systems
- 92% AFUE furnace provides solid heating efficiency above the entry-level 80% AFUE tier
- Multi-speed blower improves humidity control and comfort over basic single-speed options
- R-32 refrigerant is more environmentally responsible than outgoing R-410A
- 10-year parts warranty (with registration) provides reasonable coverage for core components
Trade-offs
- Dual-run capacitors are the most frequently reported failure point, typically needing replacement between year 5 and year 10
- Compressor lifespan averages 10 to 14 years versus 15 to 20 years for premium-brand compressors
- Evaporator coil leaks appear in a notable share of owner reports and can be costly to repair
- A minority of owners have reported refrigerant leaks in the first year, often tied to install or initial charge issues
What homeowners and pros say about Goodman
Goodman sits at roughly 2.5 out of 5 on ConsumerAffairs, a channel that skews heavily toward frustrated owners, where the most repeated complaint is repair costs accelerating after around year 7. On Google dealer reviews the picture is more balanced, with scores closer to 3.8 out of 5 across hundreds of reviews per location, and affordability is consistently the top reason buyers say they chose the brand. For a 1.5-ton system like this one, that split is worth understanding: owners who got a clean installation and kept up with maintenance tend to report reasonable satisfaction, while those who ran into issues often point to capacitor failures or coil leaks as the source of frustration.
The documented failure patterns are worth knowing going in. Dual-run capacitors are the single most reported failure point across Goodman equipment and are not unique to this model. They are a relatively inexpensive fix but an inconvenient one in a hot or cold stretch. Evaporator coil leaks show up in a meaningful share of owner reports and are a more expensive repair. Compressor lifespan on Goodman tends to average 10 to 14 years compared to the 15 to 20 years often cited for premium brands, so total cost of ownership over a 15-year horizon may narrow the gap between Goodman and a Carrier or Trane unit. HVAC pros consistently note that the install itself is the largest variable, which means choosing a skilled contractor matters at least as much as the equipment choice for a system in this tier.
Sources: ConsumerAffairs Goodman owner reviews, AHRI Directory of Certified Product Performance, U.S. DOE appliance and equipment efficiency standards, Goodman product specification sheets.
What it costs to run
At 14 SEER2, cooling this 1.5-ton system for a typical 1200-hour cooling season at the U.S. average electricity rate of $0.17/kWh works out to roughly $262 per year in cooling, about $12 less per year than a minimum-efficiency 13.4 SEER2 unit of the same size. Your real cost depends on your climate and local rate.
Method: (18,000 BTU/hr ÷ 14 SEER2) × 1200 hours ÷ 1000 × $0.17/kWh. Rate source: U.S. EIA average; cooling hours: moderate-climate estimate.
How it compares
| Brand | Comparable model | SEER2 | Stage | Price position |
|---|---|---|---|---|
| Goodman | GLXS3BN1810D | 14 | Single-stage | Value pick |
| Carrier | Comfort 14 Series (24ACC4) | 14 | Single-stage | Typically 15 to 25 percent more than Goodman |
| Trane | XR14 Series | 14 | Single-stage | Typically 15 to 25 percent more than Goodman |
| Lennox | Merit 14ACX Series | 14 | Single-stage | Typically 15 to 25 percent more than Goodman |
Competitor rows are comparable single-stage units at similar efficiency; price is relative position, not a quote.
Questions about this system
Is 1.5 tons enough for my home?
A 1.5-ton system is generally appropriate for conditioned spaces in the 500 to 800 square foot range, though the right size depends on your climate zone, insulation, window area, and ceiling height. An HVAC contractor should perform a Manual J load calculation before you buy to confirm the fit, because an oversized or undersized unit will both perform poorly.
What does the R-32 refrigerant mean for service calls?
R-32 requires a technician who holds the proper EPA Section 608 certification and has equipment rated for R-32 handling. Most established HVAC shops are already equipped, but it is worth confirming with your service provider before scheduling a call, since not every smaller or older operation has made the transition yet.
How important is professional installation for this system?
Very important. Goodman's real-world performance is widely cited by technicians as being heavily dependent on install quality. Issues like incorrect refrigerant charge, improper airflow setup, or poor condensate drainage can trigger early failures that would otherwise not occur, and some first-year refrigerant leaks reported by owners trace back to install rather than a factory defect.
What is the most likely repair I should budget for down the road?
The dual-run capacitor is the most commonly reported failure on Goodman equipment and typically needs replacement somewhere between year 5 and year 10. It is a relatively low-cost repair, usually in the 300 to 600 dollar range, and a good technician will check capacitor health during annual maintenance before it fails entirely.
Does the 10-year warranty cover the evaporator coil and compressor?
Yes, when you register the unit within 60 days of installation, Goodman's warranty covers the compressor and all functional parts, including the coil, for 10 years. Without registration, coverage drops to five years on parts, so registration is worth doing immediately after install.
Specifications
| Cooling capacity | 1.5 Ton |
| Efficiency | 14 SEER2 |
| Furnace output | 60000 BTU |
| Furnace efficiency | 92% AFUE |
| Configuration | Upflow |
| Refrigerant | R-32 |
| Model | GLXS3BN1810D |