Goodman 2 Ton 40000 BTU 13.4 SEER2 Gas/Electric Package Unit Multiposition
Check current price on AC Direct →
Key features
- 2-ton / 40,000 BTU cooling capacity for smaller homes and light commercial spaces
- 13.4 SEER2 efficiency rating, meeting current federal minimum standards
- All-in-one gas/electric package design with no separate indoor air handler required
- Multiposition cabinet compatible with rooftop horizontal or ground-level vertical installation
- Single-stage scroll compressor for straightforward on/off cooling operation
- Factory-tested unit ships pre-charged and wired to reduce field assembly time
About this system
The Goodman GPGM32404041 is a 2-ton, 40,000 BTU gas/electric package unit designed for homes and light commercial spaces where a single rooftop or ground-level cabinet handles both heating and cooling. As a packaged system, all components, the compressor, evaporator coil, and gas furnace section, live in one weatherproof cabinet rather than a split between indoor and outdoor units. That simplicity makes it a practical choice for slab-on-grade homes, manufactured housing, and buildings without interior mechanical space. The multiposition design means it can be installed horizontally on a rooftop curb or vertically on a ground pad, giving contractors flexibility on tight lots.
On the cooling side, 13.4 SEER2 sits at the current federal minimum efficiency floor for most U.S. climate zones, so this unit meets code but does not exceed it. Expect operating costs in line with other entry-level systems rather than the savings a 16 or 17 SEER2 unit would deliver over a decade. For moderate climates with limited cooling seasons, that trade-off can make financial sense. Buyers in Phoenix or Houston, where the air conditioner runs six or more months a year, may find that a higher-efficiency model recovers its premium cost faster than they expect. This unit suits replacement buyers on a budget, landlords managing rental properties, and anyone prioritizing upfront cost over long-term energy savings.
The GPGM32404041 is a competent, no-frills package unit that delivers real savings on purchase price compared to Carrier, Trane, or Lennox equivalents at this efficiency tier. Its long-term performance depends heavily on install quality and whether the buyer is prepared for likely capacitor service in the 7-to-10-year range. It is a reasonable choice for budget-conscious buyers who accept entry-level efficiency and understand the ownership trade-offs.
Overall score is the average of the five ratings above.
What we like
- Purchase price runs 15 to 25 percent below comparable Carrier, Trane, and Lennox package units
- All-in-one cabinet eliminates a separate air handler, reducing labor and refrigerant line costs
- Multiposition design offers genuine flexibility for rooftop or ground-pad installations
- Factory pre-charged and tested, which reduces some field variables if a competent installer is used
- Capacitor failures, the most common documented issue, are typically a low-cost repair in the $300 to $600 range
Trade-offs
- 13.4 SEER2 is the federal efficiency minimum, offering no energy savings advantage over premium brands at this tier
- Compressor lifespan averages 10 to 14 years versus 15 to 20 years reported for premium-brand compressors
- Evaporator coil leaks and early refrigerant loss appear in a notable share of owner reports, with first-year refrigerant issues often tied to install or charge problems
- ConsumerAffairs reviews average around 2.5 out of 5, with repair cost complaints rising after roughly year 7
What homeowners and pros say about Goodman
Homeowners discussing Goodman package units online tend to land in one of two camps. Those who had a smooth install and got lucky with capacitor timing often describe years of quiet, unremarkable service and point to the lower purchase price as the right call. Those who hit evaporator coil leaks or compressor issues after the labor warranty expired are much louder, and they dominate channels like ConsumerAffairs, which sits at roughly 2.5 out of 5 for the brand. Dealer-side Google reviews are more balanced at around 3.8 out of 5, where technicians and customers alike acknowledge affordability as the brand’s defining trait. The frustration that surfaces most often is not that the equipment failed outright but that repair costs after year 7 started to feel disproportionate relative to what was saved upfront.
HVAC technicians tend to have a measured view of Goodman. Many install it without hesitation on rental properties or budget replacement jobs, noting that the dual-run capacitor is the most predictable failure point and a straightforward fix in the $300 to $600 range. The more pointed concern from pros is compressor longevity: industry observation puts Goodman compressors at roughly 10 to 14 years on average, compared to 15 to 20 years for premium brands, a gap that matters more the longer the homeowner stays in the house. Early refrigerant loss, which shows up in a minority of first-year reports, is almost always traced back to install or charge errors rather than a factory defect, reinforcing the consistent message that contractor quality matters as much as brand selection with this equipment.
Sources: ConsumerAffairs Goodman owner reviews, AHRI Directory of Certified Product Performance, U.S. DOE appliance and equipment efficiency standards, Goodman product specification sheets.
What it costs to run
At 13.4 SEER2, cooling this 2-ton system for a typical 1200-hour cooling season at the U.S. average electricity rate of $0.17/kWh works out to roughly $365 per year in cooling, about $0 less per year than a minimum-efficiency 13.4 SEER2 unit of the same size. Your real cost depends on your climate and local rate.
Method: (24,000 BTU/hr ÷ 13.4 SEER2) × 1200 hours ÷ 1000 × $0.17/kWh. Rate source: U.S. EIA average; cooling hours: moderate-climate estimate.
How it compares
| Brand | Comparable model | SEER2 | Stage | Price position |
|---|---|---|---|---|
| Goodman | GPGM32404041 | 13.4 | Single-stage | Value pick |
| Carrier | WeatherMaster 50XC (base tier) | 13.4 | Single-stage | Typically 15 to 25 percent more than Goodman |
| Trane | Precedent (YSC Series, base tier) | 13.4 | Single-stage | Typically 15 to 25 percent more than Goodman |
| Lennox | Elite LRP14 Series | 14.0 | Single-stage | Typically 15 to 25 percent more than Goodman |
Competitor rows are comparable single-stage units at similar efficiency; price is relative position, not a quote.
Questions about this system
Is 13.4 SEER2 going to be legal to install in my state?
13.4 SEER2 meets the current federal minimum efficiency standard for package units nationwide, so it is legal to install in all U.S. climate regions as of the 2023 DOE update. A few local jurisdictions have stricter requirements, so confirm with your contractor before purchasing.
What does multiposition mean, and does it affect what I can use this unit for?
Multiposition means the cabinet is engineered to handle airflow in more than one orientation, either horizontal for rooftop curb mounting or vertical for ground-pad placement. It does not make the unit usable as a split system; all components remain in the single outdoor cabinet either way.
What is the most common repair I should expect, and how much does it cost?
Dual-run capacitor failure is the most frequently documented repair on Goodman package units, and most technicians can replace one in under an hour. Typical service call plus parts runs $300 to $600, making it one of the less expensive HVAC repairs. Budget for this becoming likely in years 7 through 10.
Does Goodman's warranty cover refrigerant leaks or coil failures on this unit?
Goodman's standard limited warranty covers parts including the compressor, heat exchanger, and functional components for 10 years when registered within 60 days of installation. Parts-only coverage means you pay labor, which can be significant for an evaporator coil replacement. Refrigerant itself is not covered under a standard warranty; whether a leak is covered depends on whether it is classified as a defective part or an install issue.
Can this unit replace a split system, or does it only work where I already have a package unit?
Package units and split systems use fundamentally different duct configurations. This unit is designed for applications with horizontal supply and return duct connections at the cabinet, typical of package unit replacements. Retrofitting it into a home designed for a split system is possible but usually requires significant ductwork modification, so it is most practical as a like-for-like package unit replacement.
Specifications
| Cooling capacity | 2 Ton |
| Efficiency | 13.4 SEER2 |
| Furnace output | 40000 BTU |
| Model | GPGM32404041 |