Goodman 3.5 Ton 14 SEER2 120000 BTU 80% Two-Stage Gas Furnace With R32 Air Conditioner Condenser And Coil System – Upflow
Check current price on AC Direct →
Key features
- 3.5-ton cooling capacity matched to the coil and condenser for a factory-rated system
- 14 SEER2 cooling efficiency, meeting current federal minimums for most U.S. regions
- 120,000 BTU two-stage gas furnace runs at partial capacity for more even heating
- 80% AFUE furnace efficiency, meaning 20% of combustion energy exits as exhaust
- R-32 refrigerant with lower global-warming potential than R-410A
- Upflow air handler orientation designed for basement or ground-level installations
About this system
This Goodman bundle pairs a 3.5-ton, 14 SEER2 R-32 condenser with an upflow evaporator coil and a 120,000 BTU, 80% AFUE two-stage gas furnace. The package is sized for larger homes, typically in the 1,800 to 2,400 square foot range depending on climate, ceiling height, and insulation. The two-stage furnace runs at a reduced capacity most of the time and only fires at full output on the coldest days, which smooths out temperature swings and cuts short-cycling compared to a single-stage unit.
The 14 SEER2 rating sits at the federal minimum efficiency threshold for most northern U.S. climate zones and is one step above minimums in the Southwest and Southeast. It will deliver meaningful savings over an aging 10 to 13 SEER system but will not match the utility-bill performance of 16 SEER2 or higher equipment. R-32 refrigerant is the industry direction of travel: it has a lower global-warming potential than R-410A and is increasingly common in new equipment, though it does require technicians who are certified to handle it. The upflow configuration means the air handler draws return air from the bottom and discharges conditioned air from the top, which suits a basement or ground-floor mechanical room feeding ductwork above.
Goodman positions this system as a full replacement kit intended to reduce sourcing friction. The condenser, coil, and furnace are matched from the factory for rated performance. That said, the system’s long-term outcome is heavily dependent on correct installation, proper refrigerant charge, and adequate airflow, areas where Goodman’s owner feedback shows the widest variance in satisfaction.
This Goodman bundle offers a complete, factory-matched system at a price point that is noticeably below comparable Carrier, Trane, and Lennox configurations. The two-stage furnace is a genuine comfort upgrade over single-stage alternatives at this price tier, but buyers should understand that 80% AFUE and 14 SEER2 are entry-level specs, and Goodman's documented track record includes capacitor failures, evaporator coil leaks, and compressor lifespans shorter than premium brands. The value proposition holds up best when installation is done carefully by an experienced technician.
Overall score is the average of the five ratings above.
What we like
- Factory-matched condenser, coil, and furnace reduces compatibility guesswork
- Two-stage furnace operation reduces temperature swings and short-cycling
- Priced roughly 15 to 25 percent below Carrier, Trane, and Lennox equivalents
- R-32 refrigerant is a forward-looking choice with lower environmental impact
- Upflow configuration is straightforward to integrate into typical basement duct layouts
Trade-offs
- 80% AFUE furnace wastes one-fifth of fuel; 95%+ AFUE units are available at moderate upcharges
- 14 SEER2 is the efficiency floor in most markets, not a standout performer on cooling bills
- Compressor life averages 10 to 14 years versus 15 to 20 for premium-brand compressors
- Evaporator coil leaks and early refrigerant loss are recurring complaints in owner reviews, often tied to install quality
What homeowners and pros say about Goodman
Homeowners who praise Goodman in Google dealer reviews, where the brand averages around 3.8 out of 5 across dealer locations, most often point to the lower installed cost as the deciding factor. For many buyers replacing a failed system on short notice, the price gap versus Carrier or Trane is real and meaningful. HVAC technicians tend to give Goodman a more measured assessment: they generally consider it a serviceable product whose longevity is unusually dependent on the quality of the installation. Proper refrigerant charge, tight connections, and correct airflow matter with any brand, but technicians note that Goodman systems seem to expose marginal installs more quickly than premium equipment does.
The more cautionary feedback surfaces on ConsumerAffairs, where Goodman scores roughly 2.5 out of 5 on a platform that skews toward dissatisfied owners. The recurring patterns there are repair costs that accelerate after roughly year 7, which aligns with the documented compressor lifespan of 10 to 14 years being shorter than the 15 to 20 years seen on premium brands. Dual-run capacitor failures are the most frequently cited service issue and are typically a quick, relatively low-cost repair in the 300 to 600 dollar range. More consequential are the evaporator coil leak reports and the minority of owners who experience refrigerant loss in the first year, a problem that technicians and Goodman’s own documentation tie back to installation and charge quality rather than a materials defect. For this specific bundle, the two-stage furnace is a genuine feature at this price point, but buyers should factor potential service costs into a realistic total cost of ownership calculation before deciding the upfront savings outweigh the trade-offs.
Sources: ConsumerAffairs Goodman owner reviews, AHRI Directory of Certified Product Performance, U.S. DOE appliance and equipment efficiency standards, Goodman product specification sheets.
What it costs to run
At 14 SEER2, cooling this 3.5-ton system for a typical 1200-hour cooling season at the U.S. average electricity rate of $0.17/kWh works out to roughly $612 per year in cooling, about $27 less per year than a minimum-efficiency 13.4 SEER2 unit of the same size. Your real cost depends on your climate and local rate.
Method: (42,000 BTU/hr ÷ 14 SEER2) × 1200 hours ÷ 1000 × $0.17/kWh. Rate source: U.S. EIA average; cooling hours: moderate-climate estimate.
How it compares
| Brand | Comparable model | SEER2 | Stage | Price position |
|---|---|---|---|---|
| Goodman | 3.5 Ton 14 SEER2 / 120K BTU 80% Two-Stage Bundle (this system) | 14 | Two-stage furnace, single-stage condenser | Value pick |
| Carrier | Performance 14 Series (24PAR / 58TP80 bundle) | 14-14.3 | Single-stage condenser, two-stage furnace options | 15 to 25 percent above this Goodman system |
| Trane | XR14c with S8X2 80% AFUE furnace | 14-14.3 | Single-stage condenser, two-stage furnace | 20 to 30 percent above this Goodman system |
| Lennox | Merit ML14XC1 with ML180UH furnace | 14-14.3 | Single-stage condenser, two-stage furnace options | 20 to 30 percent above this Goodman system |
Competitor rows are comparable single-stage units at similar efficiency; price is relative position, not a quote.
Questions about this system
Will this system work in a hot climate like Texas or Florida where stricter SEER2 minimums apply?
In the Southwest (ASHRAE Climate Zones 1 through 3, covering most of Texas, Arizona, and Florida), the federal minimum for split-system air conditioners as of 2023 is 14.3 SEER2 for systems above 45,000 BTU. A 14 SEER2 rating falls short of that threshold in those regions, so you should confirm local compliance requirements with your installer before purchasing.
What does two-stage mean on the furnace, and does it actually make a difference?
Two-stage means the furnace burner fires at a lower output (typically around 65 percent of capacity) during mild cold and only steps up to full 120,000 BTU output when temperatures drop significantly. In practice this means longer, quieter heating cycles, fewer on-off swings, and more even room temperatures compared to a single-stage furnace of the same BTU rating.
Do I need a special technician to handle R-32 refrigerant?
Yes. R-32 is an A2L refrigerant, meaning it is mildly flammable, and EPA Section 608 certification is required to handle it. Most licensed HVAC technicians are becoming familiar with it as it grows in the market, but it is worth confirming your installer has R-32 experience before booking, since improper handling is one documented source of early refrigerant leaks.
What is Goodman's warranty on this system, and are there any catches?
Goodman typically offers a 10-year parts limited warranty when the equipment is registered online within 60 days of installation by a licensed contractor. If registration is missed or the unit is self-installed, coverage often drops to 5 years. The warranty covers parts but not labor, which can be a significant out-of-pocket cost if a compressor or coil fails after year 5.
How often do Goodman capacitors fail, and what does that repair cost?
Dual-run capacitor failure is the most commonly reported issue in Goodman owner reviews, and it tends to show up anywhere from year 4 onward, particularly in regions with very hot summers that put sustained stress on the compressor. The repair is generally straightforward and runs in the 300 to 600 dollar range including a service call, making it one of the less expensive HVAC repairs, but it is worth budgeting for.
Specifications
| Cooling capacity | 3.5 Ton |
| Efficiency | 14 SEER2 |
| Furnace output | 120000 BTU |
| Configuration | Upflow |
| Refrigerant | R-32 |