Goodman 3 Ton 14.5 SEER2 80000 BTU 80% Single Stage Gas System Upflow w/ 3 Ton Coil C
Check current price on AC Direct →
Key features
- 3-ton cooling capacity paired with 80,000 BTU single-stage heating in one matched system
- 14.5 SEER2 efficiency rating meets current federal minimum standards for most U.S. regions
- 80% AFUE furnace converts 80 cents of every gas dollar directly into usable heat
- Upflow configuration delivers conditioned air upward, suited to basement and closet installs
- Single-stage operation simplifies service calls and keeps replacement parts widely available
- Factory-matched coil and condenser combination reduces sizing guesswork and supports warranty coverage
About this system
The Goodman 3-Ton 14.5 SEER2 80% AFUE Single-Stage Gas System in upflow configuration bundles a GSXN403610 condenser, a matched evaporator coil, and an 80,000 BTU 80% AFUE single-stage gas furnace into one coordinated package. At 14.5 SEER2, this system clears the federally mandated minimum efficiency threshold for most U.S. climate zones, which means it will cool reliably without the premium price tag attached to 16 SEER2 or higher equipment. The upflow furnace orientation suits the most common residential installation scenario: a basement or closet where supply air rises into the duct system above.
This combination makes the most sense for homeowners replacing aging equipment on a tight budget, landlords keeping operating costs predictable across rental properties, or buyers in moderate climates where a system runs fewer hours per year and the efficiency gap between 14.5 and 18 SEER2 translates to a smaller dollar difference on monthly utility bills. Single-stage operation means the system runs at full capacity whenever it calls for cooling or heat, which is straightforward for technicians to service but less adept at humidity control on mild days compared to two-stage or variable-speed alternatives. If your priority is keeping the total installed cost down and you have a competent installer lined up, this package delivers functional, code-compliant comfort at a price well below comparable Carrier, Trane, or Lennox systems.
This Goodman package is a workable, budget-conscious solution for homeowners who need a full replacement system without stretching into premium-brand territory. The efficiency and heating specs are solidly average, not exceptional, and long-term ownership costs depend heavily on installer quality and whether the relatively common capacitor and coil failure modes emerge. Buyers who can absorb occasional repair costs after year seven and prioritize a lower upfront price will find it a reasonable fit.
Overall score is the average of the five ratings above.
What we like
- Purchase price typically runs 15 to 25 percent below comparable Carrier, Trane, and Lennox systems
- Factory-matched coil and condenser simplifies installation and satisfies warranty requirements
- 14.5 SEER2 meets current federal efficiency minimums across most climate zones
- Single-stage components are straightforward to diagnose and widely stocked by HVAC suppliers
- Upflow furnace orientation covers the most common residential duct layout without modification
Trade-offs
- Dual-run capacitors are the most frequently reported failure point, typically requiring a 300 to 600 dollar repair around or before year seven
- Evaporator coil leaks appear in a meaningful share of owner accounts, a potential repair expense after the warranty window closes
- Compressor lifespan averages 10 to 14 years versus 15 to 20 years typical of premium-brand compressors
- Single-stage operation provides less precise humidity management on mild days compared to two-stage or variable-speed systems
What homeowners and pros say about Goodman
Homeowners who track their experience with Goodman equipment online tend to split into two camps, and the split is reflected in the brand’s ratings. On ConsumerAffairs, Goodman sits at roughly 2.5 out of 5, a score shaped by the platform’s complaint-heavy audience and a recurring pattern of repair costs climbing after about year seven. On broader Google dealer reviews, the brand averages closer to 3.8 out of 5, where the most consistent praise is straightforward: the price was meaningfully lower than competing bids. The gap between those two numbers tells most of the story about who buys Goodman and what they experience over time.
HVAC technicians who service Goodman equipment regularly point to dual-run capacitors as the most predictable failure, a relatively inexpensive fix but one that shows up with enough regularity to budget for. More consequential are evaporator coil leaks, which appear in a notable share of owner reviews and can become costly repairs once the parts warranty expires. Compressor longevity is the other honest trade-off: Goodman compressors tend to average 10 to 14 years of service life, a reasonable run but shorter than the 15 to 20 years more commonly cited for premium-brand compressors. Technicians consistently note that a careful, experienced installation closes much of the gap between Goodman and higher-priced brands, while a rushed or imprecise install can accelerate every one of these issues.
Sources: ConsumerAffairs Goodman owner reviews, AHRI Directory of Certified Product Performance, U.S. DOE appliance and equipment efficiency standards, Goodman product specification sheets.
What it costs to run
At 14.5 SEER2, cooling this 3-ton system for a typical 1200-hour cooling season at the U.S. average electricity rate of $0.17/kWh works out to roughly $506 per year in cooling, about $42 less per year than a minimum-efficiency 13.4 SEER2 unit of the same size. Your real cost depends on your climate and local rate.
Method: (36,000 BTU/hr ÷ 14.5 SEER2) × 1200 hours ÷ 1000 × $0.17/kWh. Rate source: U.S. EIA average; cooling hours: moderate-climate estimate.
How it compares
| Brand | Comparable model | SEER2 | Stage | Price position |
|---|---|---|---|---|
| Goodman | GSXN403610 with matched coil and 80% AFUE furnace | 14.5 | Single-stage | Value pick |
| Carrier | Comfort 14 Series (24ACC4) | 14 to 15 SEER2 range | Single-stage | Typically 15 to 25 percent more than the Goodman package |
| Trane | XR14 Series | 14 to 15 SEER2 range | Single-stage | Typically 15 to 25 percent more than the Goodman package |
| Lennox | Merit 14 Series (14ACX) | 14 to 15 SEER2 range | Single-stage | Typically 15 to 25 percent more than the Goodman package |
Competitor rows are comparable single-stage units at similar efficiency; price is relative position, not a quote.
Questions about this system
Does this system qualify for any federal tax credits or rebates?
At 14.5 SEER2 and 80% AFUE, this system meets basic efficiency minimums but falls below the thresholds required for the federal 25C energy efficiency tax credit, which currently requires at least 15.2 SEER2 for central air and 97% AFUE for gas furnaces. Check your local utility for any available rebates on equipment at this efficiency tier, as those vary by region.
What is covered under the Goodman warranty for this package?
Goodman offers a 10-year parts limited warranty when the system is registered within 60 days of installation by a licensed HVAC contractor. If registration is missed, coverage typically drops to five years on parts. The warranty does not cover labor costs, which can be substantial if a coil or compressor fails outside the installer's workmanship period.
How often do the capacitors on Goodman systems actually fail, and what does it cost to fix?
Dual-run capacitor failure is the single most commonly reported repair on Goodman equipment, and it tends to surface after several years of use. The repair is generally straightforward and typically runs between 300 and 600 dollars including a service call, making it an annoying but not catastrophic expense when it occurs.
Is an upflow furnace the right orientation for my house?
Upflow means the furnace draws return air from the bottom and pushes conditioned air upward into the duct system, which works best when your ducts run overhead and the furnace sits in a basement, utility closet, or main-floor mechanical room. If your ducts run beneath the floor or your furnace will sit in an attic, you would need a downflow or horizontal model instead.
Will a single-stage system struggle with humidity control in a hot, humid climate?
Single-stage systems run at full output every cycle, which means shorter run times on mild days and less opportunity to wring moisture out of the air compared to two-stage or variable-speed equipment. In consistently hot and humid climates like the Gulf Coast or Southeast, a two-stage system is generally a better fit for comfort; in drier or more temperate regions, single-stage performance is usually acceptable.
Specifications
| Cooling capacity | 3 Ton |
| Efficiency | 14.5 SEER2 |
| Furnace output | 80000 BTU |
| Configuration | Upflow |
| Model | GSXN403610 |