Goodman 3 Ton AC And 60000 BTU 80% AFUE Gas Furnace System | 15.2 SEER2 AC | Multi-Speed ECM Low NOx Furnace | Upflow | R32
Check current price on AC Direct →
Key features
- 15.2 SEER2 cooling efficiency meets current federal minimums for most U.S. regions
- 60,000 BTU 80% AFUE upflow gas furnace with multi-speed ECM blower motor
- Low NOx burner design meets California SCAQMD and similar regional air-quality rules
- R-32 refrigerant with lower global warming potential than R-410A
- ECM motor reduces furnace blower electricity use versus standard PSC motors
- Upflow configuration for basements, closets, and main-floor mechanical rooms
About this system
The Goodman 3-ton, 15.2 SEER2 split system pairs a 36,000 BTU/hr cooling capacity with a 60,000 BTU, 80% AFUE upflow gas furnace. The 15.2 SEER2 rating clears the federal minimum efficiency threshold for most U.S. climate zones and is a solid middle-ground choice for homeowners who want meaningful efficiency gains over older 13 SEER equipment without paying for a variable-speed premium system. The furnace’s multi-speed ECM blower motor improves airflow consistency and reduces electricity consumption compared to a standard PSC motor, and the Low NOx combustion design meets California and other restrictive air-quality regulations.
R-32 refrigerant is a forward-looking choice here. It carries a lower global warming potential than R-410A, and because it operates at slightly higher pressures, line sizing and service procedures differ from older installs. Homeowners should confirm their chosen HVAC contractor has worked with R-32 before. This upflow configuration suits the most common residential installation scenario: a furnace in a basement, utility closet, or first-floor mechanical room with ductwork running upward through the home. Buyers in tight crawl-space or attic applications should look at a different configuration entirely.
This system fits budget-conscious homeowners replacing an aging system who want a code-compliant, reasonably efficient combo unit without stretching into premium-brand pricing. It is less suited to buyers prioritizing the longest possible equipment life or those who expect low ongoing service costs without keeping a repair fund.
This Goodman system offers a competent, code-compliant combination of mid-tier cooling efficiency and an 80% AFUE furnace at a price point 15 to 25 percent below comparable Trane, Lennox, and Carrier bundles. The value case is real, but the long-term ownership story depends heavily on installation quality and a willingness to budget for repairs after roughly year 7. Buyers who prioritize lowest upfront cost over lowest lifetime cost will find it most appealing.
Overall score is the average of the five ratings above.
What we like
- Priced 15 to 25 percent below comparable Carrier, Trane, and Lennox systems
- 15.2 SEER2 meets or exceeds current federal minimums across most climate zones
- ECM blower motor cuts furnace fan electricity use and improves comfort consistency
- Low NOx furnace qualifies for use in California and other strict-emissions markets
- R-32 refrigerant is a more environmentally responsible choice than R-410A
Trade-offs
- Compressor lifespan averages 10 to 14 years versus 15 to 20 years for premium brands
- Dual-run capacitors are a documented early failure point, though typically a low-cost fix
- Evaporator coil leaks appear in a meaningful share of owner reports over time
- A minority of owners report refrigerant leaks within the first year, often tied to install or charge issues
What homeowners and pros say about Goodman
Homeowners discussing Goodman equipment online land in two distinct camps. The first group praises the upfront savings and points to years of trouble-free operation when a skilled technician did the install. The second group, more vocal on complaint-weighted platforms, describes climbing repair bills that start around year 7 or 8. Goodman holds a ConsumerAffairs rating of about 2.5 out of 5, a score shaped largely by owners who sought out a review channel specifically to report a problem. Google dealer reviews paint a more balanced picture at around 3.8 out of 5, where affordability is cited most often as the reason buyers chose the brand.
HVAC technicians who work on Goodman equipment frequently flag dual-run capacitors as the most common call-back item. It is a quick, low-cost fix in the 300 to 600 dollar range, but it does happen with some regularity. More consequential are the evaporator coil leaks that show up in a meaningful share of owner accounts over time, and the compressor lifespan data: Goodman compressors tend to average 10 to 14 years in real-world use, compared to 15 to 20 years for premium-brand compressors. A smaller group of owners reports refrigerant leaks within the first year, which technicians generally attribute to install or initial charge issues rather than a product defect. The consistent takeaway from the service community is that Goodman’s performance ceiling is dictated more by who installs it than by what leaves the factory.
Sources: ConsumerAffairs Goodman owner reviews, AHRI Directory of Certified Product Performance, U.S. DOE appliance and equipment efficiency standards, Goodman product specification sheets.
What it costs to run
At 15.2 SEER2, cooling this 3-ton system for a typical 1200-hour cooling season at the U.S. average electricity rate of $0.17/kWh works out to roughly $483 per year in cooling, about $65 less per year than a minimum-efficiency 13.4 SEER2 unit of the same size. Your real cost depends on your climate and local rate.
Method: (36,000 BTU/hr ÷ 15.2 SEER2) × 1200 hours ÷ 1000 × $0.17/kWh. Rate source: U.S. EIA average; cooling hours: moderate-climate estimate.
How it compares
| Brand | Comparable model | SEER2 | Stage | Price position |
|---|---|---|---|---|
| Goodman | GLXS3BA36 + GMVC8 / GMS80 series | 15.2 | Single-stage AC / Multi-speed furnace | Value pick |
| Carrier | Comfort 15 (24ACC6) + 58SC furnace | 15.2 | Single-stage AC / Single-stage furnace | Roughly 15 to 20 percent higher than this Goodman bundle |
| Trane | XR15 (4TTR5) + S8X1 furnace | 15.5 | Single-stage AC / Single-stage furnace | Roughly 20 to 25 percent higher than this Goodman bundle |
| Lennox | Merit ML15XC1 + ML196E furnace | 15.5 | Single-stage AC / Multi-speed furnace | Roughly 20 to 25 percent higher than this Goodman bundle |
Competitor rows are comparable single-stage units at similar efficiency; price is relative position, not a quote.
Questions about this system
Is R-32 refrigerant safe and can any HVAC tech service it?
R-32 is mildly flammable (A2L classification) and requires technicians who are certified and equipped for A2L refrigerants. Most newer-trained technicians are prepared for it, but you should confirm this with your contractor before installation, since not every shop has updated its tools and procedures yet.
Will 15.2 SEER2 qualify for a federal tax credit?
For split systems, the IRS Inflation Reduction Act credit generally requires 16 SEER2 or higher for central AC to qualify. At 15.2 SEER2, this unit likely does not meet the efficiency threshold for the 25C tax credit on its own; verify current IRS and ENERGY STAR guidelines with your tax professional before purchase.
What does the upflow configuration mean for my install, and what if my ductwork runs down?
Upflow means heated or cooled air exits the top of the furnace and enters ductwork above it, which suits basements and main-floor closets with overhead duct systems. If your ductwork runs downward into a crawl space or slab, you need a downflow or horizontal configuration instead.
The capacitor failure issue worries me. How much does that repair typically cost?
Dual-run capacitor replacement is one of the most common and least expensive HVAC repairs, typically running 300 to 600 dollars including labor. Keeping a service agreement or checking the capacitor at each annual tune-up can catch a weakening capacitor before it leaves you without cooling on a hot day.
How does this Goodman bundle's warranty compare to Trane or Carrier at this tier?
Goodman typically offers a 10-year parts warranty on registered equipment, which is on par with most Carrier and Trane base warranties at comparable price points. Labor is not covered by the manufacturer, so a contractor labor warranty or extended service contract matters just as much as the parts coverage.
Specifications
| Cooling capacity | 3 Ton |
| Efficiency | 15.2 SEER2 |
| Furnace output | 60000 BTU |
| Furnace efficiency | 80% AFUE |
| Configuration | Upflow |
| Refrigerant | R-32 |